® QUICK START GUIDE 

1. Remove and clean cartridge filter with FilterONE™.
   
2. If necessary, use existing water to deep-cleanse your spa for 1 to 24 hours using approximately 4oz. (113g) of JetONE™ Fast Acting Spa Cleanser.
   NEW SPAS: New spas should be filled and cleansed before starting ® as manufacturer 'wet testing' may cause build-up of mould, or other contaminants.
   
3. Drain spa and rinse surfaces with fresh water. Clean spa shell and cover. (we recommend ® Shell and Liner Cleaner) Refill and drain spa 'well' (center of spa) 2 to 3 times to assure removal of all contaminants from plumbing.
   
   NOTE: NEVER use household cleaners to clean your spa. They can damage the shell and cause foaming.
   
4. Refill spa and heat to operating temperature.
   
   Adjust pH, alkalinity, calcium hardness only if necessary.
   
   pH Range : 7.2 – 8.2
   
   Alkalinity : 80 - 120
   
   Hardness : 200  
   
   Very Hard or Well Water : Many initial water quality issues can be solved by filling your spa using the ® Spa Pre-Filter. If your water is excessively hard, you may need to use a stain and scale control product.
   
5. Add minimum recommended amount of sanitizer or one dissolving packet
   of ONEShock™ (where available) per 250 gallons (950 liters)
   (see “SANITIZERS”)
   
6. With jets and blowers running, add full bottle of ® monthly to spa.
   For heavily used spas, we recommend adding ½ to 1 cap full of ® Enzyme Active Filter Booster to the filter compartment after each filter cleaning.